REMOVAL AND INSTALLATION


caution The parts indicated by * are the bolts/nuts with friction coefficient stabilizer. In removal, ensure there is no damage, clean dust and soiling from the bearing and thread surfaces, and tighten them to the specified torque.
Pre-removal OperationEngine Room Side Cover Removal (Refer to GROUP 51 - Under Cover ).
 Post-installation Operation
  • Using Your Fingers, Press the Dust Cover to Check for a Crack or Damage.
  • Engine Room Side Cover Installation (Refer to GROUP 51 - Under Cover ).
  • Wheel Alignment Check and Adjustment (Refer to ).
  • Check the Beam Direction of the Headlamp (Refer to 54A - Headlamp Aiming ).




Removal steps


·
 Stabilizer link and stabilizer bar connection at both sides (Refer to ).


1.
 Front height sensor and lower arm connecting nut <Vehicles with headlamp automatic levelling system>
<<A>>
2.
 Lower arm assembly

REMOVAL SERVICE POINT

<<A>> LOWER ARM ASSEMBLY REMOVAL

Rotate upward the stabilizer bar so as not to interfere the lower arm removal.