|
1.Before the wheel alignment measurement, adjust the rear suspension, wheel, and tyres
in good condition.
|
|
2.Park the vehicle on a level surface to measure the wheel alignment.
|
|
Standard value:
At the centre of tyre tread: 3 ± 2 mm Toe-angle (per wheel): 0 ° 02’ - 0 ° 12’
|
|
If it is out of the standard range, adjust as follows:
|
|
Turn the toe adjusting bolt (the mounting bolt inside the body on the control link) to
adjust. Left wheels: Clockwise (+) Toe in Right wheels: Clockwise (-) Toe in Toe-in varies approximately 3.2 mm (equivalent to 0°16’ of
the toe angle for one side) for each scale mark.
|
|
Standard value: -0°30’ ± 0°45’
|
|
note |
- Difference between right and left wheels must be 0°30’ or less.
- The camber is pre-adjusted at factory and is not adjustable.
- As for vehicles with aluminium wheel, use a compensator to measure the camber and caster.
|
|