REMOVAL AND INSTALLATION


Pre-removal operationBrake Fluid Draining
 Post-installation operationBrake Fluid Supplying and Air Bleeding (Refer to ).




Removal steps


1.
 Brake hose (brake caliper side) connection


2.
 Gasket


3.
 Brake caliper assembly


·
 Brake disc run-out check and correction (only at installation) (Refer to ).


4.
 Front brake disc


5.
 Clip


6.
 Brake pipe connection

>>A<<
 7.
 Brake hose

INSTALLATION SERVICE POINT

>>A<< BRAKE HOSE INSTALLATION
1.Pass the brake hose through the hole in the body-side bracket.
2.Install the brake hose to the brake caliper.
3.Install the brake hose at the two fixing points.

4.Twist the brake hose toward the lesser torsion between the brake hose and body-side bracket as shown in the figure, and fix it to the body-side bracket with a clip.