REMOVAL AND INSTALLATION


Pre-removal operation
  • Parking Brake Rear Cable Connection (rear brake caliper side) Removal (Refer to GROUP 36 - Parking Brake Cable ).
  • Brake Fluid Draining

Post-installation operation
  • Brake Fluid Supplying and Air Bleeding (Refer to ).
  • Parking Brake Rear Cable Connection (rear brake caliper side) Installation (Refer to GROUP 36 - Parking Brake Cable ).





Removal steps


1.
Brake hose connection bolt


2.
Gasket

>>A<<
3.
Brake hose (rear brake caliper side)


4.
Rear brake caliper assembly


·
Brake disc run-out check and correction (only at installation) (Refer to ).


5.
Rear brake disc


6.
Hose clip


7.
bracket


8.
Brake tube (trailing arm side)


9.
Clip


10.
Brake tube (body floor side)

INSTALLATION SERVICE POINT



>>A<< BRAKE HOSE INSTALLATION


1.Pass the brake hose through the hole in the bracket.
2.Install the brake hose to the brake caliper.
3.Install the brake hose at the two fixing points.

4.Twist the brake hose toward the lesser torsion between the brake hose and bracket as shown in the figure, and fix it to the body-side bracket with a clip.