STOP LAMP SWITCH CHECK



caution Do not apply lubricant (grease or silicon system sprayer etc.) to the switch and the switch installation section to avoid malfunction of the switch. In addition, do not use gloves which have lubricant (grease or silicon system sprayer etc.) on them.

Check for continuity between the terminals of the switch.
Check condition
Terminal connector of tester
Normal condition
At free position
1 - 2 (for stop lamp switch)
Continuity exists
(2 Ω or less)
3 - 4 (for cruise control)
No continuity
Press the plunger from the edge of the outer case by the dimension shown in the figure.
1 - 2 (for stop lamp switch)
No continuity
3 - 4 (for cruise control)
Continuity exists
(2 Ω or less)