|
1.Remove the parts indicated in the figure, swivel the caliper body upward and retain it
with a wire or similar tool.
|
|
2.Remove the following parts from the caliper support. (1)
Shim (2)
Brake pad assembly (brake pad and wear indicator assembly) (3)
Clip
|
|
3.
caution |
Keep grease or other soiling off the pad and brake disc friction
surfaces.
|
Clean the piston part, and press the piston into the cylinder using the special tool piston
expander (MB990520).
|
|
4.Assemble the shim, brake pad assembly and clip to the caliper support, and tighten the
lock pin to the specified torque. Tightening torque: 44 ± 5 N·m <Russia> 74 ± 10 N·m <Europe>
note |
Install the brake pad assembly (with wear indicator) to the inner side of the brake disc,
making sure that the wear indicator is located on the top.
|
|
|
1.Remove the parking brake rear cable mounting bolts and nut (at the cable clamp) to
loosen the cable. (Refer to GROUP 36 - Parking Brake ).
|
|
2.Remove the parts indicated in the figure, swivel the caliper body upward and retain it
with a wire or similar tool.
|
|
3.Remove the following parts from the caliper support. (1)
Shim (2)
Brake pad assembly (brake pad and wear indicator assembly) (3)
Clip
|
|
4.
caution |
Keep grease or other soiling off the pad and brake disc friction
surfaces.
|
Clean the piston part, and press the piston into the cylinder using the special tool piston
expander (MB991621).
|
|
5.Assemble the brake pad assembly to the caliper support, and tighten the guide pin to the
specified torque. Tightening torque: 35 ± 4 N·m
note |
Install the brake pad assembly (with wear indicator) to the inner side of the brake disc,
making sure that the wear indicator is located on the bottom.
|
6.Connect the parking brake rear cable.(Refer to GROUP 36 - Parking Brake ).
|