Inspection Procedure 1: M.U.T.-III cannot communication only with ABS-ECU.


caution
  • If there is any problem in the CAN bus lines, an incorrect diagnosis code may be set. Prior to this diagnosis, diagnose the CAN bus lines (Refer to GROUP 54C - CAN Bus Diagnostics Table ).
  • Whenever ECU is replaced, ensure that the CAN bus lines are normal.
  • If the power is supplied with the earth circuit of CAN communication device open circuited, an electric potential abnormality may occur to the CAN bus lines.

COMMENTS ON TROUBLE SYMPTOM
When M.U.T.-III cannot communicate with the ABS system, the CAN bus line, ABS-ECU power supply circuit system, or ABS-ECU may be faulty.

PROBABLE CAUSES

  • Damaged wiring harness and connectors
  • ABS-ECU malfunction
  • Wrong routing of M.U.T.-III harness
  • Abnormality in battery or alternator
  • Abnormality in power supply voltage to ABS-ECU
  • ECU malfunction of other system

DIAGNOSTIC PROCEDURE

STEP 1. M.U.T.-III CAN bus diagnostics
Use M.U.T.-III to diagnose the CAN bus lines.

Q. Is the check result normal?
Check the power supply circuit, and repair if necessary (Refer to ).
Repair the CAN bus lines (Refer to GROUP 54C - CAN Bus Diagnostics Table ).