Code No. U1073 Bus-off


caution
  • If there is any problem in the CAN bus lines, an incorrect diagnosis code may be set. Prior to this diagnosis, diagnose the CAN bus lines (Refer to GROUP 54C - CAN Bus Diagnostics Table ).
  • If diagnosis code U1073 is set in ABS-ECU, always diagnose the CAN bus line. If there is any fault in the CAN bus lines, an incorrect diagnosis code may be set. In this case, the set diagnosis code is not highly reliable.
  • Whenever ECU is replaced, ensure that the CAN bus lines are normal.

DIAGNOSIS CODE SET CONDITIONS
This diagnosis code is set when ABS-ECU has ceased the CAN communication (bus off).

COMMENTS ON TROUBLE SYMPTOM
Malfunction of wiring harness, connector (s), or ABS-ECU may be present.

PROBABLE CAUSES

  • Wiring harness or connector failure of CAN bus line
  • ABS-ECU malfunction
  • Other ECU malfunction

DIAGNOSIS PROCEDURE

STEP 1. M.U.T.-III CAN bus diagnosis
Use M.U.T.-III to diagnose the CAN bus lines.

Q. Is the check result normal?
Go to Step 2.
Repair the CAN bus lines (Refer to GROUP 54C - CAN Bus Diagnostics Table ). On completion, go to Step 3.

STEP 2. Check whether the diagnosis code is reset.
Erase the diagnosis code.

Q. Is diagnosis code No. U1073 set?
Replace the hydraulic unit (integrated with ABS-ECU) (Refer to ), and then go to Step 3.
If the trouble symptom is resolved, an intermittent malfunction such as poorly engaged connector(s) or wiring harness is suspected (Refer to GROUP 00 - How to Use Troubleshooting/How to Cope with Intermittent Malfunctions ).

STEP 3. Check whether the diagnosis code is reset.
Erase the diagnosis code.

Q. Is diagnosis code No. U1073 set?
Return to Step 1.
This diagnosis is complete.