Trouble symptom
|
Inspection procedure number
|
Reference page
|
M.U.T.-III cannot communicate with the ABS/ASC
system is impossible.
|
M.U.T.-III cannot communicate with all systems.
|
-
|
Refer to GROUP 54C - Troubleshooting .
|
M.U.T.-III cannot communicate only with ASC-ECU.
|
1
|
|
ASC OFF lamp flashes at a rate of 2Hz.
|
2
|
|
Brake warning lamp stays ON with the parking brake lever
released (ABS warning lamp is OFF).
|
3
|
|
ABS warning lamp does not illuminate when ignition switch
is turned to the ON position (Engine stopped).
|
4
|
|
Brake warning lamp does not illuminate when the ignition
switch is turned to ON position (Engine stopped).
|
5
|
|
ABS warning lamp stays ON after the engine is started.
|
6
|
|
ASC warning lamp stays ON after the engine is started.
|
7
|
|
ASC OFF lamp stays ON after the engine is started.
|
8
|
|
The stability control/TCL system cannot be
disabled when ASC OFF switch is pressed for 3 seconds or more to turn the system OFF.
|
9
|
|
Abnormality in brake operation.
|
10
|
|
ASC does not operate or faulty ASC operate.
|
11
|
|
ASC-ECU power supply circuit system.
|
12
|
|
Steering wheel sensor power supply circuit system
|
13
|
|
ABS/stability control/TCL operates
too frequently.
|
14
|
|
HSA (Hill Start Assist) does not work.
|
15
|
|
HSA (Hill Start Assist) works on a flat road.
|
16
|
|
The initial check sound of hydraulic unit is loud
|
17
|
|
ESS inoperative or improper operative
|
18
|
|
The FCM cannot be turned on or off when the FCM ON/OFF
switch is operated.*
|
19
|
|
The FCM is cancelled in conjunction with a warning message
while the FCM is activated.*
|
20
|
|
The reverse signal cannot be received. <M/T>
|
21
|
|