If there is
any problem in the CAN bus lines, an incorrect diagnosis code may be set. Prior to this diagnosis,
diagnose the CAN bus lines (Refer to GROUP 54C - CAN Bus Diagnostics Table ).
If diagnosis code No.C2206 is set in ASC-ECU, always diagnose the CAN bus line.
If there is any fault in the CAN bus lines, an incorrect diagnosis code may be set. In this
case, the set diagnosis code is not highly reliable.
Before replacing the ECU, ensure that the communication circuit is normal.
When diagnosis code No.C2206 is set in ASC-ECU, the diagnosis code may also be set
in ETACS-ECU. When the diagnosis code is set in ETACS-ECU, carry out the diagnosis of the diagnosis
code for ETACS-ECU first.
OPERATION
ASC-ECU receives the vehicle information stored in the ETACS-ECU via CAN bus lines.
DIAGNOSIS CODE SET CONDITIONS
ASC-ECU communicates with ETACS-ECU via CAN bus lines. This diagnosis code is set if the
vehicle information stored in ETACS-ECU varies from the one stored when the ignition switch
was last turned on.
PROBABLE CAUSES
ETACS-ECU or ASC-ECU which was equipped with other vehicle is used.
Malfunction of ETACS-ECU
ASC-ECU malfunction
External noise interference
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-III CAN bus diagnostics
Use M.U.T.-III to diagnose the CAN bus lines.
Q.
Is the check result normal?
Go to Step 2
Repair the CAN bus lines (Refer to GROUP 54C - CAN Bus Diagnostics Table ).
On completion, go to Step 6.
STEP 2. M.U.T.-III Diagnosis code of other system
Use M.U.T.-III to check that the vehicles information-related diagnosis code is set by
the ETACS-ECU.
Q.
Is the diagnosis code set?
Troubleshoot the relevant diagnosis code, and then go to Step 3.
Go to Step 5
STEP 3. ETACS-ECU coding data check
Refer to GROUP 00 - Precautions before Service/Coding List .
Q.
Is the check result normal?
Go to Step 5
Go to Step 4
STEP 4. ETACS-ECU variant coding
Perform the variant coding to the ETACS-ECU.
Q.
Dose variant coding succeed?
Go to Step 6
Replace the ETACS-ECU (Refer to GROUP 54A - ETACS-ECU ),
and then go to Step 6.
STEP 5. Check whether the diagnosis code is reset.
(1)Erase the diagnosis code.
(2)Ignition switch "LOCK" (OFF)
(3)Ignition switch "ON"
Q.
Is diagnosis code No.C2206 set?
Replace the hydraulic unit (integrated with ASC-ECU) (Refer to ).
Then go to Step 6.
This diagnosis is complete.
STEP 6. Check whether the diagnosis code is reset.