Inspection Procedure 6: ABS warning lamp stays ON after the engine is started.



caution
  • If there is any problem in the CAN bus lines, an incorrect diagnosis code may be set. Prior to this diagnosis, diagnose the CAN bus lines (Refer to GROUP 54C - CAN Bus Diagnostics Table ).
  • Whenever ECU is replaced, ensure that the CAN bus lines are normal.

OPERATION



  • ASC-ECU sends the illumination request signal of the ABS warning lamp to the combination meter through ETACS-ECU via CAN communication.
  • ASC-ECU illuminates the ABS warning lamp via ETACS-ECU for approximately 3 seconds for valve check with the ignition switch turned to the ON position.

COMMENTS ON TROUBLE SYMPTOM


This may be caused by faults in the CAN bus line, ETACS-ECU, combination meter or ASC-ECU.

PROBABLE CAUSES



  • Damaged wiring harness and connectors
  • Malfunction of ETACS-ECU
  • Combination meter malfunction
  • ASC-ECU malfunction
  • Control stop due to the low voltage
    note Due to the abnormality in the supply voltage, the diagnosis code may not be set even when the ABS warning lamp is illuminated.

DIAGNOSIS PROCEDURE


STEP 1. M.U.T.-III CAN bus diagnosis


Use M.U.T.-III to diagnose the CAN bus lines.

Q. Is the check result normal?

Go to Step 2
Repair the CAN bus lines (Refer to GROUP 54C - CAN Bus Diagnostics Table ). Then go to Step 7.

STEP 2. M.U.T.-III diagnosis code


Use M.U.T.-III to check the diagnosis code for the ASC system.

Q. Is the diagnosis code set?

Carry out the diagnosis for the diagnosis code (Refer to ).
Go to Step 3

STEP 3. Check the ASC-ECU power supply circuit system.


Refer to .

Q. Is the check result normal?

Go to Step 4
Diagnose the power supply circuit of the ASC-ECU (Refer to ).

STEP 4. M.U.T.-III other system diagnosis code


Using M.U.T.-III, check that diagnosis code No.U0141 is not set by the combination meter system.

Q. Is the diagnosis code set?

Diagnose the combination meter (Refer to GROUP 54A - Combination Meter/Diagnosis Code ). Then go to Step 7.
Go to Step 5

STEP 5. M.U.T.-III other system diagnosis code


Using M.U.T.-III, check that diagnosis code No.U0121 is not set by the ETACS system.

Q. Is the diagnosis code set?

Perform troubleshooting on ETACS-ECU (Refer to GROUP 54A - ETACS/Diagnosis Code ). Then go to Step 7.
Go to Step 6

STEP 6. Retest the system.


(1)Erase the diagnosis code.
(2)Drive the vehicle at 10 km/h or higher.

Q. Does the ABS warning lamp turn ON and OFF normally?

Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/How to Cope with Intermittent Malfunctions ).
Replace the hydraulic unit (integrated with ASC-ECU) (Refer to ), and then go to Step 7.

STEP 7. Retest the system.


(1)Erase the diagnosis code.
(2)Drive the vehicle at 10 km/h or higher.

Q. Does the ABS warning lamp turn ON and OFF normally?

This diagnosis is complete.
Return to Step 1.