|
ASC-ECU sends the illumination request signal of the ASC warning lamp to the combination
meter through ETACS-ECU via the CAN communication.
|
|
This may be caused by faults in the CAN bus line, ETACS-ECU, combination meter or ASC-ECU.
|
|
- Damaged wiring harness and connectors
- Malfunction of ETACS-ECU
- Combination meter malfunction
- ASC-ECU malfunction
- Control is disabled due to the low voltage
note |
Due to the abnormality in the supply voltage, the diagnosis code may not be set even when
the ASC lamp illuminates.
|
|
|
Use M.U.T.-III to diagnose the CAN bus lines.
|
|
Q.
Is the check result normal?
|
|
Repair the CAN bus lines (Refer to GROUP 54C - CAN Bus Diagnostics Table ).
Then go to Step 8.
|
|
|
|
Use M.U.T.-III to check the diagnosis code for the ASC system.
|
|
Q.
Is the diagnosis code set?
|
|
Carry out the diagnosis for the diagnosis code (Refer to ).
|
|
|
|
Perform the following special function by the combination meter system, and check if the
ASC warning lamp illuminates (Refer to GROUP 54A - Combination Meter ).
|
|
- Item 2: LCD (AUTO)
- Item 6: Indicator (AUTO)
|
|
Q.
Is the check result normal?
|
|
Replace the combination meter. Then go to Step 8.
|
|
|
|
Q.
Is the check result normal?
|
|
Diagnose the power supply circuit of the ASC-ECU (Refer to ).
|
|
|
|
Using M.U.T.-III, check that diagnosis code No.U0141 is not set by the combination meter
system.
|
|
Q.
Is the diagnosis code set?
|
|
Diagnose the combination meter (Refer to GROUP 54A - Combination Meter/Diagnosis
Code ). Then go to Step 8.
|
|
|
|
Using M.U.T.-III, check that diagnosis code No.U0121 is not set by the ETACS system.
|
|
Q.
Is the diagnosis code set?
|
|
Perform troubleshooting on ETACS-ECU (Refer to GROUP 54A - ETACS/Diagnosis
Code ). Then go to Step 8.
|
|
|
|
Q.
Does the ASC warning lamp turn ON and OFF normally?
|
|
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/How
to Cope with Intermittent Malfunctions ).
|
|
|
|
Replace the hydraulic unit (integrated with ASC-ECU) (Refer to ),
and then go to Step 8.
|
|
|
|
Q.
Does the ASC lamp turn ON and OFF normally?
|
|
This diagnosis is complete.
|
|
|