INSPECTION


FCM ON/OFF SWITCH CONTINUITY CHECK

1.As shown in the figure, connect the circuit tester to the FCM ON/OFF switch as a single unit.
2.Check the continuity status when the FCM ON/OFF switch is pressed and when the switch is released.
Item
 When the FCM ON/OFF switch is released (Not being operated)
 When the FCM ON/OFF switch is pressed
Continuity between terminal No. 5 and No. 8
 No continuity
 Continuity exists (2 Ω or less)
Continuity between terminal No. 5 and No. 8
 Continuity exists
 Continuity exists