STEERING ANGLE CHECK

caution After adjusting the steering angle, always perform calibration to make ASC-ECU learn the neutral position of the steering wheel sensor. (Refer to GROUP 35C, On-vehicle Service - Steering Wheel Sensor Calibration .) <Vehicles with ASC>

1.Check that the wheel alignment is normal. (Refer to GROUP 33 - On-vehicle Service, Front Wheel Alignment Check and Adjustment (Refer to .)

2.Place the front wheel onto the turning radius gauge, and measure the steering angle. Standard value: Inner wheel 38° 50’ ± 1° 30’ (Difference between right and left wheels must be 2°00’ or less) Outer wheel (Reference value) 32° 20’

3.If the measured value is not within the standard value, adjust the tie-rod ends (right and left), and repeat Steps 1 and 2. 4.If the measured value is not within the standard value after performing Step 3, replace the steering gear and linkage assembly. (Refer to .)