|
1.Install the nut to the end of the steering column shaft. Then use the preload socket (Special tool: MB990326) to rotate the shaft at a rate of one turn per 4 to 6 seconds, and then measure the total rotation torque. Standard value:
Total rotation torque: 1.77 N·m or less Torque fluctuation: 0.6 N·m or less
note |
Rotate by 180° in left and right directions from the neutral position, and measure the total rotation torque.
|
2.When the measured value is not within the standard value, replace the steering column shaft assembly (Refer to )
|