|
If a collision accident occurs or severe impact is applied on the steering wheel, the
collision energy absorbing mechanism may have operated. Once the mechanism has operated, it
will be inoperative even it has suffered no apparent damage. Determine if the steering column
shaft can be reused by the following procedure. If the collision energy absorbing mechanism
has already operated, replace the steering column shaft assembly (Refer to ).
|
|
If any excessive radial free play on the steering wheel is found with the tilt lever in
the lock position, always replace the steering shaft assembly.
|
|
1.Remove the ignition key cover, lower column cover, and upper column cover.
|
|
2.Release the tilt lever lock.
|
|
3.Loosen the two upper steering column mounting bolts by two turns.
|
|
4.Hold the one-way capsules as shown in the figure, and then try to rock them. If there
is a slack in either of the capsules, replace the steering column shaft assembly (Refer to ).
caution |
- Be careful that nothing
is pinched between the one-way capsules and the body.
- When the replacement, removal, or installation of the steering column shaft assembly
is performed, tighten the mounting bolt of the one-way capsule side to the specified torque
first.
|
5.If no malfunction has been found after the inspection, hand-tighten the steering column
mounting bolts, and then tighten them to the specified torque. Tightening torque: 21 ± 3 N·m
|