2.When the door is not flush with the body surface: (1) Loosen the door-side hinge mounting bolts. (2) Move the door to adjust so that the door is flush with the body surface. (3) If adjustment is not possible, replace the door-side door hinge mounting bolt with the adjustment bolt (MU001031).
(5) Tighten the door-side door hinge mounting bolt to the specified torque. Tightening torque: 26 ± 6 N·m |
3.When the door is stiff to close and open: (1) Adjustment using the striker (toward the inside of the vehicle and vertical direction): Install a temporary bolt instead of the striker mounting bolt, and use the remover bar (Special tool: MB990939) and a hammer to tap the temporary bolt to the desired direction. (2) Adjustment by using the striker (toward the outside of the vehicle): Using the following tools, pull the striker toward the outside of the vehicle to adjust.
Increase or decrease the number of shims so that the striker engages with the door latch properly. |