|
|
Check that a door window glass operates smoothly and moves along the door window glass
runchannel when the window glass is fully raised and lowered. If there is a problem, adjust the
window glass by the following procedures:
|
|
|
1.Remove a door trim assembly (Refer to GROUP 52A - Door Trim  ).
|
|
|
2.Remove a waterproof film (Refer to ).
|
|
|
3.Remove the door speaker bracket (Front door) <Vehicles with audio amplifier> (Refer
to ).
|
|
|
4.Remove the door speaker cover (Rear door) <Vehicles with audio amplifier> (Refer
to ).
|
|
|
5.Remove the power window switch from the removed door trim assembly, and connect it
to the door side connector.
|
|
6.Set the channel guide mounting bolts to the adjusting hole.
7.Raise the window glass with the power window switch to check that the window glass
to door clearance is even. If there is a problem, loosen the channel guide mounting bolts to
adjust tilting up/down of the glass.
|
)
)