REMOVAL AND INSTALLATION

<Vehicles without dead lock system> Door inside handle removal 1. Door inside handle Door outside handle removal steps  2. Plug 3. Door lock key cylinder (Driver’s side) 4. Door outside handle cover 5. Door outside handle 6. Door outside handle gasket 7. Door outside handle base 8. Keyless operation switch Door latch assembly removal steps  1. Door inside handle 9. Door speaker bracket <Vehicles with audio amplifier> 10. Screw <<A>> 11. Door lock cover <<A>> 12. Door latch assembly >>B<< 13. Door inside lock cable >>B<< 14. Door inside handle cable 15. Door outside handle rod Door check removal steps · Front door speaker (Refer to GROUP 54A - Speaker .) >>A<< 16. Door check

Door inside handle removal 1. Door inside handle Door outside handle removal steps 2. Plug 3. Door outside handle cover 4. Door outside handle 5. Door outside handle gasket 6. Door outside handle base Door latch assembly removal steps  1. Door inside handle 7. Screw <<A>> 8. Door lock cover <<A>> 9. Door latch assembly >>B<< 10. Door inside lock cable >>B<< 11. Door inside handle cable 12. Door outside handle rod Door check removal steps · Rear door speaker (Refer to GROUP 54A, Speaker .) >>A<< 13. Door check

<Vehicles with dead lock system> Door inside handle removal 1. Door inside handle Door outside handle removal steps  2. Plug 3. Front door lock cover (Driver’s side) 4. Damper (Driver’s side) 5. Door lock key cylinder (Driver’s side) 6. Door outside handle cover 7. Door outside handle 8. Door outside handle gasket 9. Door outside handle base 10. Keyless operation switch 11. Clip Door latch assembly removal steps  1. Door inside handle 12. Door speaker bracket <Vehicles with audio amplifier> 13. Screw <<A>> 14. Door lock cover <<A>> 15. Door latch assembly >>B<< 16. Door inside lock cable >>B<< 17. Door inside handle cable 18. Door outside handle rod 19. Clip Door check removal steps · Front door speaker (Refer to GROUP 54A - Speaker .) >>A<< 20. Door check

Door inside handle removal 1. Door inside handle Door outside handle removal steps 2. Plug 3. Door outside handle cover 4. Door outside handle 5. Door outside handle gasket 6. Door outside handle base Door latch assembly removal steps  1. Door inside handle 7. Screw <<A>> 8. Door lock cover <<A>> 9. Door latch assembly >>B<< 10. Door inside lock cable >>B<< 11. Door inside handle cable 12. Door outside handle rod Door check removal steps · Rear door speaker (Refer to GROUP 54A, Speaker .) >>A<< 13. Door check

Remove the door lock cover in the following procedures: 1.Release the upper and lower claws of the door lock cover by using a flat-tipped screwdriver. 2.Pull the cover out a little. 3.With the cover pulled out state, slide it toward cabled side and remove it from the door latch assembly.

Install the door check with the following identification mark facing upward. Application Identification mark Front door Left door FL Right door FR Rear door Left door RL Right door RR

Connect the door inside lock cable and door inside handle cable to the door inside handle according to the identification colour marked on the cables as shown in the illustration.