INSPECTION


TAILGATE LATCH CHECK

LATCH MOTOR OPERATION CHECK

Battery connecting terminal number
 Gear operation
1 (-) - 9 (+)
 Engaged → Disengaged
1 (+) - 9 (-)
 Disengaged → Engaged

HALF LATCH SWITCH CHECK

Claw position
 Terminal number
 Normal value
ON
 2 - 3
 Continuity exists (2 Ω or less).
OFF
 2 - 3
 No continuity

FULL LATCH SWITCH CHECK

Claw position
 Terminal number
 Normal value
ON
 2 - 4
 Continuity exists (2 Ω or less).
OFF
 2 - 4
 No continuity

DOOR-AJAR SWITCH CHECK

Claw position
 Terminal number
 Normal value
ON
 5 - 10
 Continuity exists (2 Ω or less).
OFF
 5 - 10
 No continuity

NEUTRAL SWITCH CHECK

caution After checking the neutral switch, operate the tailgate latch as follows to install it. This avoids damage to the tailgate latch switch.

  1. Connect the positive battery terminal to the tailgate latch terminal No.1, and the negative battery terminal to the tailgate latch terminal No.9 for approximately one second.
  2. Connect the positive battery terminal to the tailgate latch terminal No.9, and the negative battery terminal to the tailgate latch terminal No.1 for approximately one second.
Lever position
 Terminal number
 Normal value
ON
 7 - 8
 Continuity exists (2 Ω or less).
OFF
 7 - 8
 No continuity

TAILGATE SENSOR CHECK

When the load is applied to the pressure detection sensor towards the direction shown in the figure, and when the sensor is pushed approximately 2.2 mm, the tailgate sensor turns ON.
Sensor position
 Terminal number
 Normal value
ON
 1 - 2
100 Ω or less
OFF
 1 - 2
Approximately 1kΩ

ELECTRIC TAILGATE CLOSE SWITCH INSPECTION

Switch position
 Terminal number
 Normal value
ON (Press)
 1 - 2
Continuity exists (2 Ω or less)
OFF
 1 - 2
No continuity

ELECTRIC TAILGATE MAIN SWITCH CHECK

Switch position
 Terminal number
 Normal value
ON (Press)
 1 - 2
Continuity exists (2 Ω or less)
OFF
 1 - 2
No continuity

ELECTRIC TAILGATE SWITCH CHECK

Switch position
 Terminal number
 Normal value
ON (Press)
 10 - 13
 Continuity exists (2 Ω or less)
OFF
 10 - 13
 No continuity

ELECTRIC TAILGATE BUZZER INSPECTION

Check that the electric tailgate buzzer sounds once when the terminals are connected to the battery as shown.

TAILGATE LOCK RELEASE HANDLE (TAILGATE OPEN SWITCH) CHECK

Switch position
 Terminal number
 Normal value
Push (open)
 1 - 2
Continuity exists (2 Ω or less)
Release
 1 - 2
No continuity

TAILGATE LOCK RELEASE HANDLE (TAILGATE LOCK SWITCH) CHECK

Switch position
 Terminal number
 Normal value
Push (lock)
 2 - 3
Continuity exists (2 Ω or less)
Release
 2 - 3
No continuity