LEARNING PROCEDURES OF THE SUNROOF FULLY CLOSED POSITION


SHIFTING CONDITIONS FOR THE FULLY CLOSED POSITION ADJUSTMENT MODE

  • When shifting to the forced fully closed position adjustment mode
    How to shift to the forced fully closed position adjustment mode

    1. Turn the ignition switch to the "ON" position.
    2. With the roof lid glass stopped (the position of the roof lid glass can be any position between fully opened and fully closed), press and hold the up switch for 10 seconds.
  • When the anti-trap function (safety mechanism) is activated consecutively five times
  • When the position information may be incorrect due to abnormal power supply during the sunroof operation
note When installing the sunroof assembly, or installing/replacing the sunroof motor assembly, operate the forced fully closed position adjustment mode to adjust the fully closed position.

HOW TO ADJUST THE FULLY CLOSED POSITION

<FORCED FULLY CLOSED POSITION ADJUSTMENT MODE>
1.With the roof lid glass stopped (the position of the roof lid glass can be any position between fully opened and fully closed), press and hold the up switch.
note If operating the up switch moves the sunroof normally, use the open switch to fully open the roof lid glass. After the roof lid glass stops, press and hold the up switch.
2.Use the up switch to set the roof lid glass to the tilt-up position. The roof lid glass activates for approximately 30 mm and stops automatically when the switch is pressed once. Repeat this operation until the tilt-up position is reached and hold there for 3 seconds so that the fully closed position learning is completed.

<SUCH AS WHEN THE SAFETY FUNCTION IS ACTIVATED CONSECUTIVELY FIVE TIMES>
Use the up switch to set the roof lid glass to the tilt-up position. The roof lid glass activates for approximately 30 mm and stops automatically when the switch is pressed once. Repeat this operation until the tilt-up position is reached and hold there for 3 seconds so that the fully closed position learning is completed.

HOW TO ADJUST THE FULLY CLOSED POSITION

<FORCED FULLY CLOSED POSITION ADJUSTMENT MODE>
1.With the roof lid glass stopped (the position of the roof lid glass can be any position between fully opened and fully closed), press and hold the up switch.
note If operating the up switch moves the sunroof normally, use the open switch to fully open the roof lid glass. After the roof lid glass stops, press and hold the up switch.
2.Use the up switch to set the roof lid glass to the tilt-up position. The roof lid glass activates for approximately 30 mm and stops automatically when the switch is pressed once. Repeat this operation until the tilt-up position is reached.
3.After the roof lid glass has reached the tilt-up position, press and hold the up switch for five seconds.
4.Release the up switch once, and then press and hold it again.
5.The roof lid glass will be tilted down, fully opened and then fully closed while the up switch is held down. Press and hold the up switch until the roof lid glass is fully closed and then stopped. When the roof lid glass has been fully closed and then stopped, the fully closed position learning is completed.

<SUCH AS WHEN THE SAFETY FUNCTION IS ACTIVATED CONSECUTIVELY FIVE TIMES>
1.Use the up switch to set the roof lid glass to the tilt-up position. The roof lid glass activates for approximately 30 mm and stops automatically when the switch is pressed once. Repeat this operation until the tilt-up position is reached.
2.After the roof lid glass has reached the tilt-up position, press and hold the up switch for five seconds.
3.Release the up switch once, and then press and hold it again.
4.The roof lid glass will be tilted down, fully opened and then fully closed while the up switch is held down. Press and hold the up switch until the roof lid glass is fully closed and then stopped. When the roof lid glass has been fully closed and then stopped, the fully closed position learning is completed.