When replacing the ECU, always
check that the communication circuit is normal.
DIAGNOSTIC FUNCTION
The door locking/unlocking code is automatically updated every time the doors
are locked (rolling code). ETACS-ECU stores diagnosis code No. B1A08, B1A09, B1A0A, B1A0B, B1A0C,
B1A0D, B1A0E, or B1A0F when it receives wrong signal (rolling code out of synchronisation) from
the transmitter.
JUDGMENT CRITERIA
B1A08: ETACS-ECU determines that the abnormality is present
when the rolling code received from the transmitter 1 (the first transmitter registered in ETACS-ECU)
greatly differs from the rolling code stored in ETACS-ECU.
B1A09: ETACS-ECU determines that the abnormality is present when the rolling code received
from the transmitter 2 (the second transmitter registered in ETACS-ECU) greatly differs from
the rolling code stored in ETACS-ECU.
B1A0A: ETACS-ECU determines that the abnormality is present when the rolling code received
from the transmitter 3 (the third transmitter registered in ETACS-ECU) greatly differs from
the rolling code stored in ETACS-ECU.
B1A0B: ETACS-ECU determines that the abnormality is present when the rolling code received
from the transmitter 4 (the fourth transmitter registered in ETACS-ECU) greatly differs from
the rolling code stored in ETACS-ECU.
B1A0C: ETACS-ECU determines that the abnormality is present when the rolling code received
from the transmitter 5 (the fifth transmitter registered in ETACS-ECU) greatly differs from
the rolling code stored in ETACS-ECU.
B1A0D: ETACS-ECU determines that the abnormality is present when the rolling code received
from the transmitter 6 (the sixth transmitter registered in ETACS-ECU) greatly differs from
the rolling code stored in ETACS-ECU.
B1A0E: ETACS-ECU determines that the abnormality is present when the rolling code received
from the transmitter 7 (the seventh transmitter registered in ETACS-ECU) greatly differs from
the rolling code stored in ETACS-ECU.
B1A0F: ETACS-ECU determines that the abnormality is present when the rolling code received
from the transmitter 8 (the eighth transmitter registered in ETACS-ECU) greatly differs from
the rolling code stored in ETACS-ECU.
PROBABLE CAUSES
Rolling code out of synchronisation
Malfunction of the transmitter
Malfunction of the ETACS-ECU
DIAGNOSTIC PROCEDURE
STEP 1. Synchronise the rolling code and recheck the diagnosis
code.
(1)Synchronise the rolling code.
Push the lock switch or unlock switch of transmitter twice or more.
If the keyless entry system does not resume by the procedure above, register the
key again (Refer to ).
(2)Recheck if the diagnosis code is set.
.....
Push the lock switch or unlock switch of transmitter.
.....
Check if the diagnosis code is set.
Q.
Is the diagnosis code set?
Go to Step 2.
The diagnosis is complete.
STEP 2. Check whether the diagnosis code is reset.
Replace the transmitter by which the diagnosis code is set with a new one, register the
key (Refer to .), and recheck if the diagnosis code is
set.
(1)Push the lock switch or unlock switch of transmitter.
(2)Check if the diagnosis code is set.
Q.
Is the diagnosis code set?
Replace ETACS-ECU and register the ID codes (Refer to ).