|
1.Align the channel guide mounting bolt on the door window glass with the adjusting hole
to remove it.
|
|
| caution |
If any film or the like is applied to a door window glass, use the window glass holder
(Special tool: MB990480) at the outside of the door glass to prevent the film from peeling off.
|
2.Lift the door window glass, and attach the special tool MB990480 to the glass as shown
to prevent the glass from falling.
3.Slant the door window glass and remove it upward from the inside of the door <Rear
door>.
4.Remove the power window regulator assembly.
|
.))
)
)
)
)