|
1.If the battery terminals are disconnected or the fuse for power window is removed,
the fully closed position that the power window switch has learned will be erased (initialised).
|
|
2.Operate the power window switch and fully open the door window glass.
|
|
3.
caution |
The anti-trap function will not activated until the learning
procedures of the fully closed position have been completed (because the anti-trap function
was reset).
|
Operate the power window switch and fully close the door window glass. The power window
activates for 0.7 second and stops automatically when the power window switch is pressed once.
Repeat this operation until the door window glass fully closes and release the switch once. Then,
hold the power window switch to the fully closed side again for 1 second so that the power window
switch completes learning the fully closed position.
note |
If the power window switch is operated to open the door window glass while the switch
is in learning procedure, the learning will be cancelled. If this happens, return to step 2.
|
|
|
Operate the power window switch to fully close the door window glass by one-shot up action
so that the power window switch will complete learning (no initialisation is required).
|