Inspection Procedure
13: Keyless entry hazard answerback function or the room lamp answerback function does not work
normally.
caution
Before replacing the ECU,
ensure that the power supply circuit, the earth circuit and the communication circuit are normal.
OPERATION
When the keyless entry function is used, the keyless entry hazard answerback function
or room lamp answerback function operate as set by ETACS customisation function (If the flashing
count is set to 0 with a customisation function, no answerback function is performed).
PROBABLE CAUSES
Function setting error or no setting with a customisation
Malfunction of the turn signal lamp
Malfunction of the room lamp
Malfunction of ETACS-ECU
DIAGNOSIS PROCEDURE
STEP 1. Check the hazard warning lamp
Check that the hazard warning lamp illuminate normally.
Q.
Is the check result normal?
Go to Step 2.
Refer to GROUP 54A - Inspection Procedure 1: "The hazard warning lamps
do not illuminate ."
STEP 2. Check the room lamps operation
Check that the room lamps illuminate normally.
Q.
Is the check result normal?
Go to Step 3.
Refer to GROUP 54A, The front room lamp does not illuminate normally .
STEP 3. Check the keyless entry system operation
Check that the keyless entry system operation normally.
Q.
Is the check result normal?
Go to Step 4.
Refer to Inspection Procedure 9: "Keyless entry system does not work ."
STEP 4. Check the customisation
Check that any one of the followings other than "Lock: 0, Unlock: 0" is set for "Hazard
answerback" with a customisation function.
Lock:1, Unlock:2
Lock:1, Unlock:0
Lock:0, Unlock:2
Lock:2, Unlock:1
Lock:0, Unlock:1
Lock:2, Unlock:0
note
If "Lock: 0" or "Unlock: 0" is selected, no answerback function is performed on locking
or unlocking.
Q.
Is it set to other than "Lock: 0, Unlock: 0"?
Go to Step 5.
Set "Hazard answerback" to any one other than "Lock: 0, Unlock: 0" with a customisation
function (Refer to ).
STEP 5. M.U.T.-III diagnosis code
Check if any diagnosis code is set to the KOS-ECU.
Q.
Is the diagnosis code set?
Refer to .
Go to Step 6.
STEP 6. Check of the troubles
Check that the hazard answerback and room lamp answerback functions of the keyless entry
operate.
Q.
Is the check result normal?
Intermittent malfunction is suspected (Refer to GROUP 00 - How to Use Troubleshooting/Inspection
Service Points - How to Cope with Intermittent Malfunction .)
Replace ETACS-ECU. After the replacement, perform the coding.