Inspection Procedure
14: Multimode keyless entry function does not work at all.
caution
Before replacing the ECU,
ensure that the power supply circuit, the earth circuit and the communication circuit are normal.
OPERATION
With a ETACS customisation function, using the keyless operation key, the electric-folding
door mirrors <Vehicles with electric retractable remote controlled door mirrors> can be
activated.
PROBABLE CAUSES
Malfunction of the keyless operation key
Function setting error or no setting with a customisation
Malfunction of ETACS-ECU
DIAGNOSIS PROCEDURE
STEP 1. Check the keyless entry function operation.
Check that the keyless entry system works normally.
Q.
Is the check result normal?
Go to Step 2.
Refer to inspection procedure 11 "keyless entry function does not work ."
STEP 2. Check the operation of the electric-folding door mirror.
Check that the electric folding door mirrors work normally.
Q.
Is the check result normal?
Go to Step 3.
Refer to GROUP 51 - Troubleshooting .
STEP 3. Check the customisation
Use the customisation function to check that the "Multi mode" has been set to other than
"Disabled." Vehicles with electric retractable remote controlled door mirrors
D/M: O and C.
Q.
Is it set to other than "disabled"?
Go to Step 4.
Use the customisation function to set the "Multi mode" to other than "Disabled"
(Refer to ).
STEP 4. M.U.T.-III diagnosis code
Check if any diagnosis code is set to the KOS-ECU.
Q.
Is the diagnosis code set?
Refer to diagnosis code chart .
Go to Step 5.
STEP 5. Check of the troubles
Check that the multimode keyless entry function works normally.
Q.
Is the check result normal?
Intermittent malfunction is suspected (Refer to GROUP 00 - How to Use Troubleshooting/Inspection
Service Points - How to Deal with Intermittent Malfunction ).
Replace ETACS-ECU. After the replacement, perform the coding.