Inspection Procedure
16: Power door locks with selective unlocking does not work.
caution
Before replacing the ECU,
ensure that the power supply circuit, the earth circuit and the communication circuit are normal.
COMMENT ON TROUBLE SYMPTOM
When the keyless entry function and door entry function operate normally, but there is
an error to only the power door locks with selective unlocking, ETACS-ECU may have a problem.
In addition, it is possible that the function has been set to "all doors unlock" by the customisation
function.
PROBABLE CAUSES
Malfunction of ETACS-ECU
Damaged wiring harness and connectors
DIAGNOSIS PROCEDURE
STEP 1. Check the customisation
Q.
Are the power door locks with selective unlocking enabled by the customisation function?
Go to Step 2
Set the power door locks with selective unlocking to "Enabled" by using the customisation
function. Refer to .
STEP 2. Power door locks with selective unlocking operation check
Check that the power door locks with selective unlocking operate normally by means of
the keyless entry function or door entry function.
Q.
Is the check result normal?
Go to Step 5
NO (Does not work by means of keyless entry function) : Go to Step 3
NO (Does not work by means of door entry function) : Go to Step 4
NO (Does not work by means of either functions) : Go to Step 5
STEP 3. Keyless entry system operation check
Press the unlock switch of the keyless operation key and check that only the driver’s
door is unlocked. Then, press the unlock switch once again within 2 seconds after that to check
that the front passenger’s door, rear doors, and tailgate are unlocked.
Q.
Does the keyless entry function work normally?
Go to Step 5
NO (Only the driver’s door is not unlocked.) : Replace ETACS-ECU.
NO (The driver’s door, front passenger’s door, rear doors, and tailgate
are not unlocked.) : Refer to Inspection Procedure 8: "Keyless entry function does not work ."
STEP 4. Door entry function operation check
Press the lock/unlock switch (driver’s side) and check that only the
driver’s door is unlocked. Then, press the lock/unlock switch (driver’s
side) once again within 2 seconds after that to check that the front passenger’s door,
rear doors, and tailgate are unlocked.
Q.
Does the door entry function work normally?
Go to Step 5
NO (Only the driver’s door is not unlocked.) : Replace ETACS-ECU.
NO (The driver’s door, front passenger’s door, rear doors, and tailgate
are not unlocked.) : Refer to Inspection Procedure 6: "Driver’s door lock/unlock
switch does not work ."
STEP 5. Check of the troubles
Check that the power door locks with selective unlocking works normally.
Q.
Is the check result normal?
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection
Service Points - How to Cope with Intermittent Malfunction ).