DISASSEMBLY AND REASSEMBLY



Pre-removal and post-installation operation
  • Headlamp washer removal and installation (Refer to .)






Disassembly steps


1.
Front fog lamp wiring harness


2.
Harness clamp


3.
Radiator grille
<<A>>
>>A<<
4.
Rivet


5.
Front bumper reinforcement


6.
Front fog lamp bezel <Vehicles with front fog lamps>


7.
Front fog lamp <Vehicles with front fog lamp>


8.
Front bumper lamp hole cover <Vehicles without front fog lamp>


9.
Front bumper face

DISASSEMBLY SERVICE POINT



<<A>> RIVETS REMOVAL



Use a drill (Φ 4.0 mm) to make a hole in the rivet to break it, and remove the rivet.

REASSEMBLY SERVICE POINT



>>A<< RIVETS INSTALLATION



Use a rivet tool shown as in the illustration to connect the parts with rivets by the following procedures:
1.Insert the rivet into a corresponding location.
2.Set the rivet tool at a portion A of rivet.
3.While pushing the flange surface of the rivet onto parts to be fixed with the rivet tool, press the handle of the tool.
4.Thin part of portion A of the rivet will be cut off and the part is fixed in position.