|
|
Gently lift and remove the side air dam. If there is any double-sided tape remaining on
the side air dam, remove according to the following instructions.
|
|
|
<Remove double-sided tape remaining on the body surface>
|
|
1.Attach protection tape all the way along the edges of the double-sided tape which is still
adhering to the body.
|
|
2.Scrape off the double-sided tape with a resin spatula as much as possible.
3.Peel off the protection tape.
4.Wipe the body surface and clean it with a rag moistened with Parts Cleaner (MZ100387
or equivalent).
|
|
|
<Remove double-sided tape remaining on side air dam and adhere double-sided tape
(when re-using side air dam)>
|
|
1.Scrape off the double-sided tape on the side air dam with a resin spatula as much as possible.
2.Wipe the side air dam surface and clean it with a rag moistened with Parts Cleaner
(MZ100387 or equivalent).
3.Remove only a small portion of the residual adhesive.
4.Adhere the double-sided tape as specified on the side air dam (Refer to double-sided
tape adherence location  ).
|
|
|
1.Use the parts cleaner (MZ100387 or equivalent) wipe off the adhesion surface to decrease
it.
|
|
|
2.Apply the specified primer to the double-sided adhesive tape surface. Then dry it
off sufficiently.
Specified primer: 3M K-500
|
|
3.Tear off the double-sided tape backing paper.
| note |
If attach the adhesive tape to the edge of the backing paper, it will be easy to tear
off.
|
4.Install the side air dam.
| note |
If the double-sided tape is difficult to affix in cold temperature, etc., warm the bonding
surfaces of the body and side air dam to about 40- 60°C before affixing the
tape.
|
5.Firmly press in the side air dam.
|
)
)
)
)
)