REMOVAL AND INSTALLATION






1.
Front three-diamond mark (Refer to )

>>A<<
2.
Rear three-diamond mark (Refer to )

>>A<<
3.
MITSUBISHI mark

>>A<<
4.
CLEAR TEC mark

>>A<<
5.
OUTLANDER mark

>>A<<
6.
4WD mark <4WD>

INSTALLATION SERVICE POINT



>>A<< MARK APPLICATION


1.Installation position
Attach each mark to the position shown in the illustration.
2.





3.Installation procedure
(1) Use Parts Cleaner (MZ100387 or equivalent) to clean the mark installation surfaces on the body.
(2)
caution When attaching the marks, the ambient temperature should be 20 - 38°C and the air should be completely free of dust. If the ambient temperature is lower than 20°C, the marks and the places on the vehicle body where the marks are to be attached should be heated to 20 - 30°C.
Peel off the protection sheet on the back of the marks to paste it on the installation position.