|
Remove the windshield wiper motor and inspect it at the harness connector.
|
|
Connect the battery to the windshield wiper motor to inspect the operation of motor rotation
at low or high speed.
|
|
1.Connect the battery to the windshield wiper motor as shown in the illustration (A).
|
|
2.Run the windshield wiper motor at low speed, then disconnect the battery in the middle
of the motor rotation and check to see that the motor stops.
|
|
3.Connect the battery to the windshield wiper motor as shown in the illustration (B).
|
|
4.Connect the terminals of the windshield wiper motor connector as shown in the illustration
(B).
|
|
5.Check to see that the windshield wiper motor runs at low speed and then stops at the
automatic stop position.
|
|
Check continuity between the switch terminals.
|
Switch position
|
Tester connection
|
Specified condition
|
OFF
|
6 - 11, 6 - 10, 6 - 9, 6 - 8
|
Open circuit
|
Windshield mist wiper switch
|
6 - 11
|
Continuity (Less than 2 ohms)
|
Windshield intermittent wiper switch <vehicles without auto
lamp> Windshield auto wiper switch <vehicles with auto lamp>
|
6 - 10
|
Windshield low-speed wiper switch
|
6 - 9
|
Windshield high-speed wiper switch
|
6 - 8
|
|
|
|
Check the windshield wiper switch (mist, intermittent, low speed and high speed) from
the ETACS diagnosis codes for proper operations (Refer to GROUP 54A, ETACS ).
|