|
1.
caution |
- Before performing the adaptation, check if the lighting control sensor (rain sensor)-related diagnosis code is set. (if set, refer to GROUP 54A, HEADLAMP DIAGNOSIS CODE CHART ).
- Turn the wiper switch to the OFF position.
|
|
|
2.Clean the windshield in fine weather.
|
|
3.Wipe the surface of the windshield thoroughly, and check that the surface is dry.
|
|
4.Turn the ignition switch to the ON position.
|
|
5.Turn the ignition switch to the LOCK (OFF) position.
|
|
6.
caution |
Before connecting or disconnecting M.U.T.-III, always turn the ignition switch to the LOCK (OFF) position.
|
Connect the M.U.T.-III to the diagnosis connector.
|
|
7.Turn the ignition switch to the ON position.
|
|
8.Wipe the windshield surface of the lighting control sensor section thoroughly, and check that the surface is dry.
|
|
9.Select "LIN" on the "System Select" screen, and press the "OK" button.
|
|
10.Select "Rain light sensor" on the "System Select" screen, and press the "OK" button.
|
|
11.Select "Special Function" on the "Rain light sensor" screen.
|
|
12.Select "Rain Sensor Adaptation" on the "Special Function" screen.
|
|
13.Press the "OK" button, and execute the "Rain Sensor Adaptation."
|
|
14.Press the "OK" button after the execution screen is displayed.
|
|
15.Press the "OK" button after "Completed" is displayed.
|