REMOVAL AND INSTALLATION



caution Before removing the front seat assembly, refer to GROUP 52B, Service Precautions and Side Airbag Module (s) .




Removal steps


1.
Headrestraint


2.
Front seat anchor cover


3.
Rear seat anchor cover
<<A>>

·
Wiring harness connectors connection

>>A<<
4.
Front seat assembly

REMOVAL SERVICE POINT



<<A>> WIRING HARNESS CONNECTOR DISCONNECTION



Disconnect the following wiring harness connectors:
Connector number
Connector name
D-18 (2)
Power seat connector <Vehicle with power seat>
D-19 (4 - black)
Heated seat connector (LH) <Vehicle with heated seat>
D-20 (2 - natural)
Seat belt switch connector (Driver’s side)
D-21 (2 - yellow)
Side air bag module (squib) connector (LH) <Vehicles with side-airbag>
D-22 (2 - yellow)
Side air bag module (squib) connector (RH) <Vehicles with side-airbag>
D-23 (2 - natural)
Seat belt switch connector (Passenger’s side)
D-24 (4 - black)
Heated seat connector (RH) <Vehicle with heated seat>

note When disconnecting the side air bag module connectors of D-21 and D-22, unlock the connector by sliding the locking button to the direction of the arrow as shown in the figure, and then disconnect the connector.

INSTALLATION SERVICE POINT



>>A<< FRONT SEAT ASSEMBLY INSTALLATION



1.Confirm that both the seat slides are locked, and then temporarily tighten all the bolts shown in the figure so that no load is applied to the front seat cushion.
2.Tighten all the bolts to the specified torque.
Tightening torque: 43 ± 8 N·m