Code No.B1426
Malfunction of G-sensor inside right side impact sensor
Code No.B1436 Malfunction
of G-sensor inside left side impact sensor
caution |
If the diagnosis code B1426
or B1436 is set to SRS-ECU, be sure to diagnose the CAN bus line.
|
TROUBLE JUDGEMENT
- Analogue G-sensor for side impact does not operate.
- Characteristics of analogue G-sensor for side impact are abnormal.
- Output of analogue G-sensor for side impact is abnormal.
PROBABLE CAUSES
- Malfunction of right side impact sensor (with code No. B1426)
- Malfunction of left side impact sensor (with code No. B1436)
|
STEP 1. M.U.T.-III CAN bus diagnostics.
|
|
Use M.U.T.-III to diagnose the CAN bus lines.
|
|
Q.
Is the check result normal?
|
|
Go to Step 2.
|
|
|
|
Repair the CAN bus line (Refer to GROUP 54C -
Troubleshooting ).
|
|
|
|
STEP 2. Side impact sensor check.
|
|
(1)Check that the negative battery terminal is disconnected. If the negative battery
terminal is connected, disconnect it.
|
|
(2)A side impact sensor is checked in the following way.
- Replace the right side impact sensor {In case of code B1426 (Regardless
of "Active" or "Stored" faults)}
with the new part.
- Replace the left side impact sensor {In case of code B1436 (Regardless
of "Active" or "Stored" faults)}
with the new part.
|
|
(3)Connect the negative battery terminal.
|
|
(4)After erasing the diagnosis code memory, check the diagnosis code again.
|
|
(5)Disconnect the negative battery terminal.
|
|
Q.
Is the diagnosis code No. B1426 or B1436 set?
|
|
Go to Step 3.
|
|
|
|
The procedure is complete.
|
|
|
|
(1)Check that the negative battery terminal is disconnected. If the negative battery
terminal is connected, disconnect it.
|
|
(2)Replace the SRS-ECU with a new one (Refer to ).
|
|
(3)Connect the negative battery terminal.
|
|
(4)After erasing the diagnosis code memory, check the diagnosis code again.
|
|
(5)Disconnect the negative battery terminal.
|
|
Q.
Is the diagnosis code No. B1426 or B1436 set?
|
|
Return to Step 1.
|
|
|
|
The procedure is complete.
|
|
|