|
If any malfunction is found in the following inspections, replace the air bag module with
a new one.
|
|
- Pad cover dent, crack or deformation
- Check the harness and connector for damage and the terminal for deformation.
- Check the air bag inflator cases for dents, cracks or deformation.
- Check the air bag module for proper installation.
|
|
If any malfunction is found in the following inspections, replace the clock spring with
a new one.
|
|
1.Check the connectors and protective tubes for damage and the terminal for deformation. 2.Check the case for damage. 3.Check that the continuity exists between the following connector terminals.
- Clock spring connector terminal 1 and horn connector terminal
1
- Clock spring connector terminal 5 and horn connector terminal 5
|
|
4.As shown in the Figure, connect the circuit tester to special tool extra fine probe (MB992006)
and check to see that there is a charge between the terminals.
|