|
(1)Disconnect the connector, and measure at the wiring harness side.
|
|
(2)Measure the resistance between the connector terminal of lamp which does not illuminate and the body earth.
- Measure the resistance between the headlamp assembly (position: LH) or (position: RH) connector (earth terminals) and body earth.
- Measure the resistance between the rear combination lamp (tail: LH) or (tail: RH) connector (earth terminals) and body earth.
- Measure the resistance between the licence plate lamp (LH) or (RH) connector (earth terminals) and body earth.
OK: Continuity exists (2 Ω
or less)
|