Before
replacing the ECU, ensure that the power supply circuit, the earth circuit and the communication
circuit are normal.
When the ETACS-ECU of vehicles without KOS is replaced, the encrypted code of the ignition
key needs to be registered to the ETACS-ECU. (If the encrypted code is not registered, the engine
cannot be started. Register the encrypted code as described in Immobilizer System - How
to Register Key ID .)
DIAGNOSTIC FUNCTION
When the hazard warning lamp fuse is blown, the ETACS-ECU sets the diagnosis code No.
B16A6.
JUDGEMENT CRITERIA
With the diagnosis code not set, when the blown fuse of hazard warning lamp is detected
three times consecutively, the ETACS-ECU sets the diagnosis code No. B16A3.
PROBABLE CAUSES
Damaged harness wires and connectors
Malfunction of the ETACS-ECU
DIAGNOSIS PROCEDURE
STEP 1. Fuse check
Check if the turn-signal lamp fuse is normal.
Q.
Is the check result normal?
Go to Step 2.
Replace the turn-signal lamp fuse.
STEP 2. Check whether the diagnosis code is reset.
(1)Erase the diagnosis code.
(2)Turn the ignition switch from "LOCK" (OFF) position to "ON" position.