CHECK PROCEDURE FOR EACH MULTI INFORMATION DISPLAY SCREEN <HIGH CONTRAST METER>



caution When there are TV towers, substations, or broadcasting stations which emit strong radio waves in proximity, on rare occasions, a warning is displayed on the multi information screen for a few seconds. This is caused by the reception of strong radio waves, and there is no functional problem.

WARNING SCREEN


When malfunctions occur to the vehicle, the following warning screens are displayed. If these screens are not displayed normally or if they continue to be displayed even after the factor is eliminated, take measures according to the action procedure.
Display content
Message
Factor
Action procedure


REMOVE KEY
Displayed with the sounding of buzzer when the driver’s door is opened with the ignition switch in the LOCK (OFF) position and the key inserted in the ignition switch key cylinder.
If the ignition key reminder buzzer does not sound, diagnose the ignition key reminder buzzer. Refer to .


TURN OFF LIGHTS
Displayed with the sounding of buzzer when the driver’s door is opened with the ignition switch at the LOCK (OFF) or ACC position and the lighting switch at the tail or head position.
If the lighting monitor warning buzzer is not being sounded, perform the troubleshooting for the lighting monitor warning buzzer. Refer to .


KEY BATTERY LOW
Displayed when the keyless operation key battery is running low.
If the warning screen is not displayed normally or if the screen continues to be displayed, perform the troubleshooting for the KOS. Refer to GROUP 42B - Diagnosis code chart .


KEY NOT DETECTED
Displayed if carrying a keyless operation key with different ID code or the keyless operation key is outside the operative range.


KEY STILL IN VEHICLE
Displayed when the keyless operation key take-out monitoring function or keyless operation key confinement prevention function is in operation.


CHECK DOORS
Displayed when the door ajar prevention function is in operation.


KEYLESS OPERATION SYSTEM SERVICE REQUIRED
Displayed when there is a malfunction to KOS.
If the warning screen is not displayed normally or if the screen continues to be displayed, perform the troubleshooting for the KOS. Refer to GROUP 42B - Diagnosis code chart .


KEY NOT DETECTED INSERT KEY INTO KEY SLOT
Displayed when the keyless operation key cannot be detected.


REMOVE KEY FROM KEY SLOT
Displayed when the key is not removed from the key slot located in the glove box.


-
Displayed when the lock/unlock switch of front door outside handle is pressed while in the power mode other than OFF.


-
Displayed when the driver’s door is open while in the power mode other than OFF.
If the warning screen is not displayed normally or if the screen continues to be displayed, perform the troubleshooting for the OSS. Refer to GROUP 42B - Diagnosis code chart .


IMMOBILIZER SYSTEM SERVICE REQUIRED
Displayed when a malfunction occurs to the immobilizer system.


PUSH ENGINE SWITCH WHILE TURNING STEERING WHEEL
Displayed when the steering lock is in operation.


STEERING LOCK SERVICE REQUIRED
Displayed when a malfunction occurs to the steering lock.


SHIFT TO P POSITION
Displayed when the engine is stopped while the selector lever is in other than P position.
If the warning screen is not displayed normally or if the screen continues to be displayed, perform the troubleshooting for the OSS. Refer to GROUP 42B - Diagnosis code chart .


STEERING WHEEL UNLOCKED
Displayed when the steering lock is not in operation.


ELECTRICAL SYSTEM SERVICE REQUIRED
Displayed when a malfunction occurs to the power supply system.


PRESS BRAKE PEDAL TO START ENGINE
Displayed when the engine switch is pressed without the brake pedal depressed at starting the engine. <A/T, CVT>


PRESS CLUTCH PEDAL TO START ENGINE
Displayed when the engine switch is pressed without the brake pedal depressed at starting the engine. <M/T>
If the warning screen is not displayed normally or if the screen continues to be displayed, perform the troubleshooting for the OSS. Refer to GROUP 42B - Diagnosis code chart .


BRAKE SYSTEM SERVICE REQUIRED
Displayed when the brake fluid amount is insufficient or a malfunction occurs to the brake device.
If the warning screen is not displayed normally or if the screen continues to be displayed, check the brake fluid or brake device. Refer to GROUP 35A - On-vehicle Service .


RELEASE PARKING BRAKE
Displayed if vehicle is driven with the parking brake engaged.
If the warning screen is not displayed normally or if the screen continues to be displayed, check the parking brake. Refer to GROUP 36 - On-vehicle Service .


ABS SERVICE REQUIRED
Displayed when a malfunction occurs to the anti-skid braking system (ABS).
If the warning screen is not displayed normally or if the screen continues to be displayed, perform the troubleshooting for the ABS or ASC. Refer to GROUP 35B - Trouble Symptom Chart <ABS> or GROUP 35C - Trouble Symptom Chart <ASC>.


ENGINE OVERHEATING STOP SAFELY
Displayed when overheated.
If the warning screen is not displayed normally or if the screen continues to be displayed, perform the troubleshooting for the engine. Refer to GROUP 13A - Trouble Symptom Chart .


TRANSMISSION OVERHEATING SLOW DOWN
Displayed when the transmission oil temperature becomes high.
If the warning screen is not displayed normally or if the screen continues to be displayed, check the CVT diagnosis code. Refer to GROUP 23A - Diagnosis Code Chart .


TRANSMISSION SERVICE REQUIRED
Displayed when there is a malfunction to the CVT.


FASTEN SEAT BELT
Displayed when the ignition switch is turned ON without the driver’s seat belt fastened.
If the warning screen is not displayed normally or if the screen continues to be displayed, perform the troubleshooting for the seat belt reminder warning lamp. Refer to .


FUEL SYSTEM SERVICE REQUIRED
Displayed when there is a malfunction to the fuel system.
If the warning screen is not displayed normally or if the screen continues to be displayed, check the combination meter diagnosis code. Refer to .


REFUEL
Displayed when the remaining fuel amount is small.
If the warning screen is not displayed normally or if the screen continues to be displayed, refuel immediately.


LOW OIL PRESSURE
Displayed when there is a malfunction to the engine oil circulation system.
If the warning screen is not displayed normally or if the screen continues to be displayed, check the oil pressure. (Refer to GROUP 12 - On-vehicle Service .) Then if the oil pressure is normal, perform the troubleshooting for the engine. (Refer to GROUP 13A - Trouble symptom chart .)


CHARGING SYSTEM SERVICE REQUIRED
Displayed when there is a malfunction to the charging system.
If the warning screen is not displayed normally or if the screen continues to be displayed, check the charging system. Refer to GROUP 16 - On-vehicle service - Output current test and Regulated voltage test .


AIRBAG SYSTEM SERVICE REQUIRED
Displayed when there is a malfunction to the SRS air bag or to the pre-tensioner mechanism.
If the warning screen is not displayed normally or if the screen continues to be displayed, perform the troubleshooting for the SRS air bag/pre-tensioner mechanism warning lamp. Refer to GROUP 52B - Trouble symptom chart .


ASC SYSTEM SERVICE REQUIRED
Displayed when there is a malfunction to the ASC.
If the warning screen is not displayed normally or if the screen continues to be displayed, perform the troubleshooting for the ASC. Refer to GROUP 35C - Trouble symptom chart .


4WD SYSTEM SERVICE REQUIRED
Displayed when there is a malfunction to the electronically-controlled 4WD system.
If the warning screen is not displayed normally or if the screen continues to be displayed, perform the troubleshooting for the electronically-controlled 4WD system. Refer to GROUP 27C - Trouble symptom chart .


4WD SYSTEM OVERHEATING SLOW DOWN
Displayed when there is a malfunction to the electronically-controlled 4WD differential temperature is high.


POSSIBLE ICY ROADS
Displayed with the sounding of buzzer when the ambient temperature is 3 °C or less.
If the warning buzzer does not sound when the combination meter displays 3 °C, perform the troubleshooting for the freeze warning buzzer. Refer to .


POWER STEERING SERVICE REQUIRED
Displayed when there is a malfunction to the EPS.
If the warning screen is not displayed normally or if the screen continues to be displayed, perform the troubleshooting for the EPS. Refer to GROUP 37 - Trouble symptom chart .


-
If any of the doors or tailgate is not closed completely, the location of the ajar door is displayed with the sounding of buzzer.
If the door ajar warning buzzer does not sound, perform the troubleshooting for the door ajar warning buzzer. Refer to .


ALARM ACTIVATING
Displayed while the security alarm is in operation.
If the warning screen is not displayed normally or if the screen continues to be displayed, carry out the troubleshooting for the security alarm (Refer to ).


CLOSE HOOD
Displayed when the hood is open.
If the warning screen is not displayed normally or if the screen continues to be displayed, check the hood latch switch input signal. Refer to .


DPF SYSTEM SERVICE REQUIRED
Displayed when the engine oil level has increased excessively.
If the warning screen is not displayed normally or if the screen continues to be displayed, check the diesel engine diagnosis code. Refer to GROUP 13D - Diagnosis Code Chart .


CHECK DPF SYSTEM
An excessive amount of particulate matter (PM) accumulates inside the diesel particulate filter (DPF).
If the warning screen is not displayed normally or if the screen continues to be displayed, check the diesel particulate filter system (DPF).


-
Is displayed when your vehicle may collide with a vehicle-traveling-ahead.
If the warning screen is not displayed normally or if the screen continues to be displayed, check the ASC diagnosis code. Refer to GROUP 35C - Diagnosis Code Chart .


FCM BRAKE ACTIVATED
Is displayed after the FCM turns off.


FCM TEMPORARILY NOT AVAILABLE
Is displayed when the FCM is inactive temporarily.


FCM SERVICE REQUIRED
Is displayed when the FCM is defective.


FCM FAR MODE
Is displayed when the FCM warning timing is switched to "FAR."


FCM NEAR MODE
Is displayed when the FCM warning timing is switched to "NEAR."


-
Displayed when the vehicle-traveling-ahead is decelerating too much, another vehicle interrupts your lane, or your vehicle is too close to the vehicle-traveling-ahead due to poor deceleration on downhill while the ACC is in progress.
If the warning screen is not displayed normally or if the screen continues to be displayed, check the ACC diagnosis code. Refer to GROUP 17 - Diagnosis Code Chart .


ACC TEMPORARILY NOT AVAILABLE
Displayed when the ACC system is defective.


APPLY BRAKE
If the vehicle-traveling-ahead stops during the ACC operation, your vehicle will also stop automatically. When the driver does not depress the brake pedal under this condition, this icon will appear.
-
LANE DEPARTURE
A message will appear when the system enters the warning condition.
If the warning screen is not displayed normally or if the screen continues to be displayed, carry out the troubleshooting for the LDW (Refer to ).


LDW NOT AVAILABLE
Displayed when the internal temperature in the LDW camera reaches 85 °C or more.


LDW SERVICE REQUIRED
Displayed when the LDW system is defective.

OTHER SCREENS


The screen displays the operation state of each system, periodic checkup timing, or timing for taking a rest during driving. If the screen display differs from the actual system operation state or if the screen is not displayed at the set timing, take measures according to the action procedure.
Display content
Message
Factor
Action procedure
a

4WD ECO
Displayed in accordance with operation state of the 4WD switch.

  1. "4WD ECO" mode is selected.
  2. "4WD AUTO" mode is selected.
  3. "4WD LOCK" mode is selected.
If the 4WD switch position and screen do not agree with each other, perform the troubleshooting for the 4WD. Refer to GROUP 27C - Trouble symptom chart .
b

4WD AUTO
c

4WD LOCK


ROUTINE MAINTENANCE REQUIRED
Displayed when the set period elapses.
-


REST REMINDER
Displayed when the set time elapses.
-