Inspection Procedure
11: Parking brake reminder buzzer does not sound. Inspection Procedure 12: Brake warning
lamp does not illuminate.
caution
Before replacing the combination meter, be sure to check
that the power supply circuit, earth circuit, and communication circuit are normal.
COMMENTS ON TROUBLE SYMPTOM
If the parking reminder buzzer does not sound or the brake warning lamp does not come
on at a speed above 8 km/h with the parking brake switch ON, the parking brake switch
input circuit, the vehicle speed signal circuit, the combination meter, the wiring harness or
its connector may be defective.
PROBABLE CAUSES
Malfunction of vehicle speed signal circuit
Malfunction of parking brake switch
Malfunction of combination meter
Damaged harness wires and connectors
DIAGNOSIS PROCEDURE
TEP 1. Check the speedometer.
Check that the speedometer in the combination meter operates normally.
Q.
Is the check result normal?
Go to Step 2.
Troubleshoot the combination meter. Refer to .
STEP 2. Check the parking brake switch.
Refer to GROUP 36 - On-vehicle Service, Parking Brake Switch Check .
Q.
Is the check result normal?
Go to Step 3.
Replace the parking brake switch.
STEP 3. Check of short to power supply circuit (connect) in BRK line
between combination meter connector and parking brake switch connector.
Q.
Is the check result normal?
Go to Step 4.
Repair the connector(s) or wiring harness.
STEP 4. M.U.T.-III Special Function
Using M.U.T.-III, select "Test" from the special function of the combination meter. Execute
the following item to check the liquid crystal display.
Item 3: Buzzer (AUTO)
Item 6: Indicator (AUTO)
Q.
Is the check result normal?
Go to Step 5.
Replace the combination meter.
STEP 5. Retest the system.
The parking brake reminder buzzer function should work normally.
Q.
Is the check result normal?
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How
to use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunction ).