|
1.Disconnect the sensor connector and connect special tool test harness (MB991658) as shown. 2.Turn the ignition switch to the "ON" position. 3.Measure the voltage of sensor connector terminal No. 2.
|
|
4.Check that voltages show the values described in the graph according to the sensor operation
angle.
|
|
1.Disconnect the sensor connector and connect special tool test harness (MB991658) as shown. 2.Turn the ignition switch to the "ON" position. 3.Measure the voltage of sensor connector terminal No. 2.
|
|
4.Check that voltages show the values described in the graph according to the sensor operation
angle.
|