REMOVAL AND INSTALLATION

caution

If the battery current sensor or engine-ECU is replaced, make the battery current sensor learn the zero point (Refer to GROUP 00, Precautions Before Service - Battery Current Sensor Calibration

<2000 (EUROPE)> or

<2200>).

Pre-removal operation

Air Cleaner Intake Duct Removal (Refer to GROUP 15 - Air Cleaner <2000, 2400> or <2200>).

Post-installation operation

Air Cleaner Intake Duct Installation (Refer to GROUP 15 - Air Cleaner <2000, 2400> or <2200>).

<RUSSIA>

			Removal steps
		1.	Connection of the battery harness (negative battery terminal)
		2.	Fusible link box cover
		3.	Connection of the battery harness (positive battery terminal)
		4.	Connection of fusible link box
		5.	Connection of the battery harness (positive battery terminal)
		6.	Battery terminal assembly (positive battery terminal)
		7.	Battery holder
		8.	Battery bolt
		9.	Battery
		10.	Battery tray

<2000 (EUROPE)>

			Removal steps
		1.	Battery current sensor
		2.	Connection of the battery harness (negative battery terminal)
		3.	Fusible link box cover
		4.	Connection of the battery harness [positive battery terminal]
		5.	Connection of fusible link box 1P assembly
		6.	Connection of fusible link box 6P assembly
		7.	Connection of the battery harness [positive battery terminal]
		8.	Battery terminal assembly (positive battery terminal)
		9.	Battery holder
		10.	Battery bolt
		11.	Battery
		12.	Battery tray

<2200>

			Removal steps
		1.	Battery current sensor
		2.	Connection of the battery harness (negative battery terminal)
		3.	Battery terminal assembly [negative battery terminal]
		4.	Fusible link box cover
		5.	Connection of the battery harness (positive battery terminal)
		6.	Connection of fusible link box 1P assembly
		7.	Connection of fusible link box 6P assembly
		8.	Connection of the battery harness [positive battery terminal]
		9.	Battery terminal assembly [positive battery terminal]
		10.	Battery holder
		11.	Battery bolt
		12.	Battery
		13.	Battery cover
		14.	Battery tray