- Wiper/Washer Switch Removal (Refer to
).
- Wiper/Washer Switch Installation (Refer to ).
Pre-removal Operation
|
Post-installation Operation
|
) |
|
| note | Other than the single unit supplying of key reminder switch and key ring antenna assembly
as well as of ignition switch, they are also supplied as the mechanical steering lock assembly
(mechanical steering lock, steering lock bracket, steering lock bolt, key reminder switch and
key ring antenna assembly, and ignition switch are supplied as a set). For how to remove the
mechanical steering lock, steering lock bracket, and steering lock bolt, refer to GROUP 37 - Steering
Shaft Disassembly and Reassembly . |
REMOVAL SERVICE POINT |
<<A>> STEERING LOCK CYLINDER REMOVAL |
| 1.Insert the key into the steering lock cylinder, and turn the ignition key to the "ACC"
position. |
) ) |
2.Using a flat-tipped precision screwdriver or similar tool, press the lock button located
at the part "A" shown in the figure. |
) ) |
3.Subsequently, using a flat-tipped precision screwdriver or similar tool, press the step
generated at the part "B" toward the direction of front passenger’s seat. Then, pull
out the ignition key, and then remove the steering lock cylinder. |