Code No.U1007
Security alarm sensor LIN timeout <Vehicles with security alarm sensor>
caution
Before replacing the ECU, ensure that the communication
circuit is normal.
JUDGEMENT CRITERIA
The ETACS-ECU will set diagnosis code No. U1007 when no signals are received from the
security alarm sensor.
PROBABLE CAUSES
Faulty security alarm sensor
Malfunction of the LIN bus
DIAGNOSIS PROCEDURE
STEP 1. Resistance measurement at the security alarm sensor
connector
(1)Disconnect the connector, and measure at the wiring harness side.
(2)Measure the resistance between the security alarm sensor connector (earth terminal)
and the body earth. OK: Continuity exists (2 Ω or less)
Q.
Is the check result normal?
Go to Step 3.
Go to Step 2.
STEP 2. Check of open circuit in body earth line between security
alarm sensor connector (earth terminal) and the body earth.
Q.
Is the check result normal?
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How
to use Troubleshooting/inspection Service Points - How to Cope with Intermittent
Malfunction ).
Repair the connector(s) or wiring harness.
STEP 3. Voltage measurement at the security alarm sensor connector.
(1)Disconnect the connector, and measure at the wiring harness side.
(2)Measure the voltage between the security alarm sensor connector (LIN2 terminal)
and the body earth. OK: System voltage
Q.
Is the check result normal?
Go to Step 5.
Go to Step 4.
STEP 4. Check of short to power supply, short to earth, and open circuit
in LIN2 line between ETACS-ECU connector and security alarm sensor connector.
Q.
Is the check result normal?
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How
to use Troubleshooting/inspection Service Points - How to Cope with Intermittent
Malfunction ).
Repair the connector(s) or wiring harness.
STEP 5. Check of open circuit in BUP1 line between ETACS-ECU connector
and security alarm sensor connector.
Q.
Is the check result normal?
Go to Step 6.
Repair the connector(s) or wiring harness.
STEP 6. Check whether the diagnosis code is reset.
Check again if the diagnosis code is set to the ETACS-ECU.
(1)Erase the diagnosis code.
(2)Turn the ignition switch from the LOCK (OFF) position to the ON position.
(3)Check if diagnosis code is set.
Q.
Is the diagnosis code set?
Replace the security alarm sensor.
A poor connection, open circuit, or other intermittent malfunctions in the LIN
bus lines between the security alarm sensor and the ETACS-ECU (Refer to GROUP 00 - How
to Cope with Intermittent Malfunction ).