REMOVAL AND INSTALLATION

<VEHICLES WITH FRONT FOG LAMP>

For the removal and installation of daytime running lamp, refer to the descriptions for front fog lamp

<VEHICLES WITHOUT FRONT FOG LAMP>

Post-installation Operation

Front Fog Lamp Aiming Adjustment (Refer to ).

			Removal steps
		1.	Front fog lamp bezel
	>>A<<	2.	Fog lamp assembly (daytime running lamp)
<<A>>		3.	Daytime running lamp bulb
		4.	Fog lamp unit (daytime running lamp)

REMOVAL SERVICE POINT

<<A>> DAYTIME RUNNING LAMP BULB REMOVAL

caution

Do not touch the bulb surface with bare hands or dirty gloves. If the bulb surface (glass part) gets dirty, immediately clean it with alcohol or thinner. After drying completely, install the bulb.

INSTALLATION SERVICE POINT

>>A<< DAYTIME RUNNING LAMP ASSEMBLY INSTALLATION

Tighten the mounting screws to the specified torque in the order shown.
Tightening torque: 1.2 ± 0.7 N·m