Code No.U0230 Power Gate CAN Timeout



caution
  • If diagnosis code No. U0230 is set, be sure to diagnose the CAN bus line.
  • When replacing the CAN box unit, always check that the communication circuit is normal.

DIAGNOSTIC FUNCTION


If the signal from electric tailgate control unit cannot be received, the CAN box unit sets the diagnosis code No. U0230.

JUDGEMENT CRITERIA


With the statuses that the ignition switch is at ON position, system voltage is 10 - 16 V (data from ETACS-ECU), and there is no malfunction to the power supply fuse (IOD fuse), or odometer value is 80.5 km or more, if the communication with electric tailgate control unit cannot be established for 2,500 ms or more, the CAN box unit determines that a problem has occurred.

PROBABLE CAUSES



  • Malfunction of CAN bus line
  • Malfunction of electric tailgate control unit
  • Malfunction of CAN box unit

DIAGNOSIS PROCEDURE


STEP 1. M.U.T.-III CAN bus diagnostics


Use the M.U.T.-III to diagnose the CAN bus lines.

Q. Is the check result normal?

Go to Step 2
Repair the CAN bus line (Refer to GROUP 54C - Troubleshooting ).

STEP 2. M.U.T.-III other system diagnosis code


Check again if the diagnosis code is set to the electric tailgate control unit.

Q. Is the diagnosis code set?

Troubleshoot the electric tailgate control unit (Refer to GROUP 42A - Tailgate <vehicles with electric tailgate> - Diagnosis Code Chart ), and then go to Step 3.
Go to Step 3

STEP 3. Check the M.U.T.-III Diagnosis code for other systems


Check if the diagnosis code No. U0230 is set to ETACS-ECU.

Q. Is the diagnosis code set?

Go to Step 4
Go to Step 5

STEP 4. Diagnosis code recheck


Check again if the diagnosis code is set to the CAN box unit.
(1)Erase the diagnosis code.
(2)Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
(3)Check if the diagnosis code is set.

Q. Is the diagnosis code set?

Replace the electric tailgate control unit.
A poor connection, open circuit or other intermittent malfunction in the CAN bus line between the CAN box unit and the electric tailgate control unit. (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction .)

STEP 5. Check whether the diagnosis code is reset.


Check again if the diagnosis code is set to the CAN box unit.
(1)Erase the diagnosis code.
(2)Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
(3)Check if diagnosis code is set.

Q. Is the diagnosis code set?

Replace the CAN box unit.
A poor connection, open circuit or other intermittent malfunction in the CAN bus line between the CAN box unit and the electric tailgate control unit. (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction .)