Diagnosis Item
10: Diagnose when the M.U.T.-III cannot receive the data sent by SRS-ECU
caution
When servicing a CAN bus line,
earth yourself by touching a metal object such as an unpainted water pipe. If you fail to do,
a component connected to the CAN bus line may be broken.
FUNCTION
The diagnostic result demonstrates that "the M.U.T.-III cannot receive the sent data from
the SRS-ECU" when the M.U.T.-III checks the periodically sent data from each ECU and cannot
receive the SRS-ECU data only.
TROUBLE JUDGEMENT CONDITIONS
M.U.T.-III judges the trouble when the periodically sent data from SRS-ECU cannot be received.
PROBABLE CAUSES
Damaged harness wires and connectors
Power supply circuit malfunction of the SRS-ECU
Malfunction of the SRS-ECU
DIAGNOSIS PROCEDURE
STEP 1. Connector check: joint connector (CAN3) <LHD> or
joint connector (CAN4) <RHD> and SRS-ECU connector
caution
The strand end of the twist wire should be within 10 cm from
the connector. For details refer to .
When checking the joint connector, ensure that its wiring harness side and its short pins
are not damaged.
Q.
Is the check result normal?
Go to Step 2.
Repair the defective connector. Replace the joint connector as necessary.
STEP 2. Resistance measurement at joint connector (CAN3) <LHD>
or joint connector (CAN4) <RHD> and SRS-ECU connector.
caution
A digital multimeter should be used. For details refer to .
caution
The test wiring harness should be used. For details refer
to .
(1)Disconnect joint connector (CAN3) <LHD> or joint connector (CAN4) <RHD>
and the SRS-ECU connector, and measure at the wiring harness side.
(2)Turn the ignition switch to the LOCK (OFF) position.
(3)
caution
When measuring the resistance, disconnect the negative battery
terminal. For details refer to .
Ensure that the negative battery terminal is disconnected.
(4)Continuity between joint connector (CAN3) terminal No.8 and SRS-ECU connector terminal
No.30 <LHD> OK: Continuity (2 Ω or less)
(5)Continuity between joint connector (CAN3) terminal No.19 and SRS-ECU connector
terminal No.29 <LHD> OK: Continuity (2 Ω or less)
(6)Continuity between joint connector (CAN4) terminal No.9 and SRS-ECU connector terminal
No.30 <RHD> OK: Continuity (2 Ω or less)
(7)Continuity between joint connector (CAN4) terminal No.20 and SRS-ECU connector
terminal No.29 <RHD> OK: Continuity (2 Ω or less)
caution
Strictly observe the specified wiring harness repair procedure.
For details refer to .
Q.
Is the check result normal?
<All the resistances measure 2 Ω or less> Power supply
to the SRS-ECU may be suspected. Diagnose the SRS. Refer to GROUP 52B - Troubleshooting - .
NO : <Either or all of the resistances measure more than 2 Ω> Repair
the wiring harness between joint connector (CAN3) <LHD> or joint connector (CAN4) <RHD>
and the SRS-ECU connector.