If the diagnosis
code No. U0141 is set, be sure to diagnose the CAN bus line.
Before replacing the ECU, ensure that the power supply circuit, the earth circuit
and the communication circuit are normal.
DIAGNOSTIC FUNCTION
When the LDW-ECU receives no signal from the ETACS-ECU for 2.5 seconds or more, it will
store diagnosis code No. U0141.
JUDGEMENT CRITERIA
When the LDW-ECU receives no signal from the ETACS-ECU for 2.5 seconds or more, it will determine
that the system is defective.
PROBABLE CAUSES
Malfunction of the CAN bus
Malfunction of ETACS-ECU
Power supply circuit to ETACS-ECU defective
Malfunction of the LDW-ECU
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-III CAN bus diagnostics
Use the M.U.T.-III to diagnose the CAN bus lines.
Q.
Is the check result normal?
Go to Step 2
Repair the CAN bus line (Refer to GROUP 54C - Troubleshooting ).
On completion, go to Step 2.
STEP 2. M.U.T.-III other system diagnosis code
Check again if the diagnosis code is set to the ETACS-ECU.
Q.
Is the diagnosis code set?
Diagnose the ETACS-ECU (Refer to ).
Go to Step 3
STEP 3. Check the M.U.T.-III Diagnosis code for other systems
Check if a diagnosis code, which relates to CAN communication-linked systems below, is
set.
Combination meter
Code No. U0141: ETACS CAN timeout
Q.
Is the diagnosis code set?
Go to Step 4
Go to Step 5
STEP 4. Check whether the diagnosis code is reset.
Check again if the diagnosis code is set to the LDW-ECU.
(1)Erase the diagnosis code.
(2)Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
(3)Check if diagnosis code is set.
Q.
Is the diagnosis code set?
Replace the ETACS-ECU.
The trouble can be an intermittent malfunction such as a poor connection or open
circuit in the CAN bus lines between the ETACS-ECU and the LDW-ECU (GROUP 00 - How
to use Troubleshooting/inspection Service Points - How to Cope with Intermittent
Malfunction ).
STEP 5. Check whether the diagnosis code is reset.
Check again if the diagnosis code is set to the LDW-ECU.
(1)Erase the diagnosis code.
(2)Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
(3)Check if diagnosis code is set.
Q.
Is the diagnosis code set?
Replace the LDW-ECU.
The trouble can be an intermittent malfunction such as a poor connection or open
circuit in the CAN bus lines between the ETACS-ECU and the LDW-ECU (GROUP 00 - How
to use Troubleshooting/inspection Service Points - How to Cope with Intermittent
Malfunction ).