|
1.Assemble a gauge manifold on the high pressure service valve.
|
|
2.Disconnect the A/C pressure sensor connector and connect the special tool test
harness (MB991658) as shown. 3.Start the engine and then turn ON the air conditioner switch.
|
|
4.At this time, check to see that the voltage of the A/C pressure sensor connector
terminal No. 2 reflects the specifications of the figure.
note |
- The allowance shall be defined as ±5%.
- The A/C pressure sensor is incorporated in the discharge flexible hose,
and the high-pressure service valve is incorporated in liquid pipe B. Therefore, the pressure
at the A/C pressure sensor is 0.1 to 0.3 MPa higher than that at the gauge manifold.
|
|