REMOVAL AND INSTALLATION

			Power transistor removal steps
		·	Bottom cover assembly (passenger’s side) (Refer to GROUP 52A - Instrument Panel ).
		1.	Power transistor
			Blower motor removal steps
		·	Bottom cover assembly (passenger’s side) (Refer to GROUP 52A - Instrument Panel ).
		2.	Hose
		3.	Blower motor

		Air mixing damper control motor, mode selection damper control motor removal steps
	·	Foot duct (Refer to ).
<<A>>	4.	Air mixing damper control motor <Vehicles with Single-zone AUTO A/C> or Air mixing damper control motor (driver’s side) <Vehicles with Dual-zone AUTO A/C>
<<A>>	5.	Air mixing damper control motor (passenger’s side) <Vehicles with Dual-zone AUTO A/C>
<<A>>	6.	Mode selection damper control motor

			Outside/inside air selection damper control motor removal steps
		·	Glove box, Globe box assembly (Refer to GROUP 52A - Instrument Panel ).
		7.	Clean air filter cover
	>>B<<	8.	Clean air filter
<<A>>	>>A<<	9.	Outside/inside air selection damper control motor

REMOVAL SERVICE POINT

<<A>> AIR MIXING DAMPER CONTROL MOTOR, OUTSIDE/INSIDE AIR SELECTION DAMPER CONTROL MOTOR, MODE SELECTION DAMPER CONTROL MOTOR REMOVAL

note

A normal plate-type ratchet driver is recommended.

INSTALLATION SERVICE POINT

>>A<< OUTSIDE/INSIDE AIR SELECTION DAMPER CONTROL MOTOR INSTALLATION

Install the outside/inside air selection damper control motor while pressing the outside/inside air selection damper from the hole of the blower motor.

>>B<< CLEAN AIR FILTER INSTALLATION

Install the clean air filter in the direction shown.