SUPPORT LOCATIONS FOR LIFTING AND JACKING

SUPPORT POSITIONS FOR A GARAGE JACK, AXLE STANDS, SINGLE-POST LIFT OR DOUBLE-POST LIFT AND PLATE TYPE LIFT

GARAGE JACK

caution

Be sure to support the specified locations only. Otherwise, deformation of vehicle may occur.
Be careful to avoid damage to the side sill garnish.

AXLE STANDS AND A SINGLE-POST LIFT OR DOUBLE-POST LIFT

caution

If rubber attachments with grooves that are too thick are used at the front support positions, the front fender may become bent, so be sure to use rubber attachments with groove thicknesses of 18 mm or less.

If attachments which are not high enough are used, they may damage areas such as the side step. Be sure to use attachments which are high enough, or remove the side step if not using attachments.

PLATE TYPE LIFT

caution

To avoid damaging the side sill garnish, put a wooden block between the side sill and a lift.

Support the side sill flange with a lift.